When I close my sprint I want the incomplete issues to move to the top of the backlog, How do I make

[Deleted user]

When closing a sprint we have two options, either to move non-done issues to next sprint or to move them to the backlog.  We want to start moving issues to the TOP of the backlog. I'm not sure if that is possible & if so how do I make that happen?

[Bill Sheboy]

Hi @[deleted] 

Short answer: you cannot do this exactly, but can work around it.

Longer answer:

When the issues are selected for a sprint and the sprint starts, the items are in whatever rank order they were in when added to the sprint.  When an issue does not complete in a sprint, and returns to the backlog, it goes back to the rank order where was before...relatively.  (The rank mechanism, LexoRank, handles the situation that other items may have moved around since the sprint started.)

A work-around for this would be (and yes, I understand this isn't ideal):

• Create an anchor, dummy issue a the top of the backlog.  Keep it there.
• During sprint planning, once the work has been identified, move it all to the top of the backlog.  Then move it into the sprint.
• Any incomplete work returning to the backlog will be above the anchor.
• Repeat.

Also, I checked the suggestions for improvements, and there is a similar item here:

When removing issue from an active sprint on board, prompt user where to place that issue, such as backlog or future sprint

Best regards,

Bill

[Deleted user]

Thanks Bill,

 It's a bit too complicated for us. We'll just close sprints and roll to the next open sprint.  You'd think there'd be a simpler way to just indicate 'move to top or bottom of the backlog' :(

thanks,

Nancy