Automation for-each loop

[Chasovskikh Kirill]

Hi! 

I need to create subtasks from values in a customfield. The known way is to create branches, where i can check - does the customfield contain Value1?  And create subtask, if it contains.

But if i have a lot of values, this way is too hard.

Is there any way to create For-Each loop? For each value in customfield create subtask.

Thank you!

[Nic Brough -Adaptavist-]

How are you doing the assignment?  And are you refreshing the page that the calendar is on after the assignment?

[Ben Weisman]

It seems Christine is clicking on the Assign button. And she said it works fine 95% of the time but 5% the tasks seem to get stuck. I have not ever had this issue myself but I reassign tasks by clicking the actual assignee field.

[Nic Brough -Adaptavist-]

So it pops up the box and asks her to select an assignee?

When she next reports it, can you check that the assignee has not been updated for everyone else as well?

Could you read the history of the issue to see if it is recording an assignee change?

[Ben Weisman]

Task history says she changed it, and it is reflected inside the task. Just not in any gadgets.

[Nic Brough -Adaptavist-]

Ok, are you refreshing the dashboard after her change?

[Ben Weisman]

Yes. :)

[Nic Brough -Adaptavist-]

Ok, can you try indexing the project the issue is in, and then refresh the dashboard?

[Ben Weisman]

An additional tidbit, I went into the task that Christine was asking about. I assigned it to myself and then back to him and that fixed the issue.....any ideas???