We have a page with a table and about 20 rows. When I click on Edit the page is displayed with nothing on it. We are using Confluence Cloud.
Hey @Julio Sarmiento welcome to the community!
Perhaps you can try to:
1) Edit
2) Publish with a blank page
3) Restore the older version of the page
Hope the above helps!
TC, thank you. That did work. However, there are a lot of pages that this is happening on. Apparently there is something else going on with Confluence. I would hate to have to do it to all the pages, but it is a start.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
@Julio Sarmiento Thanks for your reply. It seemed that no incident was reported on this page. If the problem persists, perhaps you can report it through the support.
Hope the above helps!
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi @Julio Sarmiento Is this happening on pages that were either migrated from an on premise instance, or updated from the old page editor to the new page editor?
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi @Laura Campbell _Seibert Group_ We're having the same issue but (with reference to your previous post) we're only experiencing it with pages that have been updated from the old editor to the new editor. In 'Page History' a new page version with the comment "Version published after converting to the new editor" has been created and the page can be viewed correctly, but when the page is edited only the page title is visible without any content.
The steps mentioned by the OP result in the same behaviour.
Thoughts?
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
I am having the exact same issue. what other work arounds do you suggest?
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.