Does the Confluence Status Macro have a limit on text display?

[Debbie.dananberg]

I just tried to add my feature name - not too long  - using the status macro in a table. My text seems to be cut off and displayed as Feature Name...   

[Diego]

Hello there Debbie!
The Status Macro does truncate the text shown during edit mode. However, in view mode the entire text should be shown, such as:



Could you clarify if the situation is present in edit mode or view mode? Hope this addresses your question!

[Lisa Sintum]

how did u have all display? coz i have experience that when i preview it was the complete wording but when i click save and it appear at my table (tho the table size is sufficient to diplay all wording) it come out as In Progr.... 

please help

[Debbie.dananberg]

Actually, Lisa, you are correct. When i use the macro in a table, the text is still cut off with ...  When i display without a table, it works fine.  Does anyone know how to get this to work in a table?  Thanks!

[Diego]

Hello there @Debbie.dananbergand @Lisa Sintum!

I tried replicating the behaviour with both Fixed Width and also Responsive Width tables. Even then, I was unable to.

Here are a few screenshots:

Here, I tested with fixed width tables. One has a layout with two sections and the other does not.

Here, I used responsive width tables. One has a two sections layout and the other does not:

Could you send us some screenshots with dummy content that replicated the issue? Be careful to create test content so your actual data is not displayed here publicly.

[Raquel Velez]

@Diego Hello! Was this ever resolved? I am experiencing the same issue today. Whether it is in edit mode, preview, or saved, the text always shows truncated :/ 

Preview

Publish

Edit