Checkbox Group in Confiform

[Kritika Buttan]

Hello All,

Very Basic questions but i am stuck.

Field 1 : Checkbox Group which will have below options.

Option 1

Option 2

Option 3

Now i need to create Field 2 which should be visible only if Option 2 is checked.

I tried with form validation by show field option if Entry.Field1=Option2 but no luck.

[Alex Medved _ConfiForms_ · Accepted solution]

Hi @Kritika Buttan 

You can set up a show/hide rule https://wiki.vertuna.com/display/CONFIFORMS/ConfiForms+Field+Definition+Rules#ConfiFormsFieldDefinitionRules-Showfield that does that

If "Option 1" is the label you have then the condition (for show field rule) would be

Field1.label:Option 1

And the field name parameter (the one that this rule will show will be Field 2)

Alex

[Kritika Buttan]

This is not working, I have field definition for Field 2, hence it is showing up on the form.

Is the validation different from field definition.

[Alex Medved _ConfiForms_]

Not quite what I was trying to explain..,

Try setting the condition

ImpactedPG.label:Advice PG

[Kritika Buttan]

This should be working but the challenge is i have POD Name (Field2) already on the form.

1. should i hide it in field definition? how?

2. form Rules should be applied before the form definition?

Form already have:

[Alex Medved _ConfiForms_]

You set the very same rule with "reverse" parameter enabled

[Kritika Buttan]

Lovely, Its working. Thank you soo much :)