Workflow Transitions

Question

Is it possible that if you have an "On-Hold" status, and you want to transition this back to the last step is this possible (or a previous step it has been in(... I know I can add a transition back, but only issue is that, i would need to add all transitions and this will then allow the user to step a status... for example.

If i have, design, build, test, release, warranty steps, and place the issue on hold at build, i then want to allow the user to take off OnHold, but only go back to previous steps... and not be able to select test, release, warranty...

Thoughts?

Vijay Khacharia · Answer

Hi,

I think below should work.

- On each transition going to "On Hold" put the status name in a custom field.

- On each transition out of "On Hold" check that customfield value and compare the status where the transition goes to using the condition "Value Field Condition" available in JIRA Suite utilities plugin. This plugin is available for JIRA OnDemand.

Another option is to use below plugin.

https://marketplace.atlassian.com/plugins/com.innovalog.jmwe.jira-misc-workflow-extensions

The plugin has a condition to check what was the most recent status.

https://innovalog.atlassian.net/wiki/display/JMWE/Conditions#Conditions-1-PreviousStatusCondition

Hope this works for you. I have not used jira misc workflow extensions.

Vijay

Ivar · Answer

Then that is out of my scope of knowledge. But it seems that @Vijayhave some ideas :)

Saadiq Patel · Answer

i want to have from on-hold a transition to all steps in the workflow, but only be able to transition to one of them if the issue has been in that step in the past, it should not be able to jump from Test to Onhold to Warranty, but OnHold to Design, Build, Test or Release...