Change capability_key during job

unknown

Hi,

we are using a bamboo-plugin, which needs a custom capability key with a specific installation path. But the installation is getting done during the job, so I have to reset the capability key to the new location of the installation. 

I googled and tried to find a solution, but could not find any. Maybe you guys have any ideas.

Cheers

 

Daniel Santos_157bm4

Hi @[deleted],

If I understood you correctly, you are trying to configure a capability that will be installed during a build and you don't know the path of it before its installation. Can you confirm that?

If this is the case, the only solution I can think of right now is:

1. Set the custom capability path with a fixed location prior to the build.
2. Configure your plugin to use that capability.
3. Before the plugin runs (after the capability installation is done), make sure you create a symbolic link connecting the fixed path configured before with the new one where your binary will be found.

I hope that makes sense.