Test Execution Burndown not displaying the right data when a cycle other than the first listed is selected. Any workarounds?

[Effie Karageorgos]

Test Execution Burndown not displaying the right data when a cycle other than the first listed is selected. Any workarounds?

when the first cycle is selected the data chart properly

for any oter cycle does not chart the data but displayes the cycle in the title. If you edit again the first cycle is shown as being selected.

[Effie Karageorgos · Accepted solution]

After looking at it more carefully the only problem is that when you open the gadget for editing it shows the first test cycle as being selected. The data in the chart though are correct so this is a small nuisance.