Hi Draw.io
Two issues in one here, that might be resolved with the same change:
1) When inserting a Electical/Switch(SPST) the connection port is not aligned/fitting to the drawing of the switch. There is a gap that is not nice, it does not look connected :-(
2) The aligning of the switch with other elements (e.g. a resistor) is not easy, because the connection post is not centeres on the switch. So in normal aligne mode the SPST is centered with the resistor. The resistor has the connection port vertically centered. The SPST has the connection port under the center. The connection line is not horiizontal.
And I find it not easy to adjust the elements to have a horizontal connection line...
Kind ragards,
Michael
This is resolved in latest release.
We've opened [DRAW-14] for this
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.